Remodels – My Most Valuable Advice

DIY Basement Waterproofing Tips

If your home’s basement foundation was not appropriately constructed, probably a demoralizing water seeping or condensation situation may occur whenever it rains heavily. This is the last thing many homeowners will want to see, but you don’t need to panic when it happens. If your basement foundation is leaking water, waterproofing coating can be a lasting solution.

Before taking any action, finding a good quality waterproofing product should be your first thing to ponder. This will work well if the block walls are in the right form because preventing water seepage has not been an easy thing. If the walls are not in the perfect condition, start by brushing the loose mortar as well as the broken blocks. Using a wire brush, clean the dirt and grease, plus any other contaminant from the surface. Use a quick-dry cement to shut the cracks or openings on the foundation wall.

However, it is highly recommended to check the manufacturer’s guidelines before you start patching the cracks. Don’t forget that the mortar should be mixed with the waterproof carefully, putting in mind the extent of moisture seepage. Many homeowners make the mistake of adding too much or too little waterproof, which may cause other problems down the line. It’s even wiser to use more of waterproofing because it implies a stronger sealing.
Why No One Talks About Tips Anymore

If you apply a thin waterproof, it might not prevent the seeping appropriately. If the water leakage is too much, an additional coating is necessary. However, ensure the coating work is done directly on the building material. Ensure every crack is properly sealed.
The Path To Finding Better Tips

Always be careful when shopping for the coating products. ‘Water repellant’ and ‘Waterproofing’ are two terms that many manufacturers use interchangeably. You should note that these are two different things. Water repellant is used to coat above the concrete and do not actually prevent water seepage under hydrostatic pressure.

Waterproofing, on the other hand, is often used to prevent moisture leakage under hydrostatic pressure. Waterproofing coating can be applied on exterior and interior walls, on and below the concrete. A heavy downpour flowing towards a house, damaged gutters, wind-driven rain, or high water table can be a cause of hydrostatic pressure.

It is important for every homeowner to know the difference between a moisture seepage and condensation. To know the cause of wetness on the foundation, place an aluminum foil on the wall and leave it for several days. If the side in contact with the wall is wet, there is a seepage problem. If the upper side is wet, definitely condensation is the issue of concern.
If both sides of the foil are wet, moisture seepage and condensation are occurring at the same time. So, use a dehumidifier to get rid of moisture condensation, and a good waterproof to shut moisture seepage.